**Job Description – Electrical Technical Assistant** We are seeking an **Electrical Technical Assistant** to support maintenance activities, electrical testing, and operation of equipment and instruments used in the factory. The professional must perform duties in accordance with safety regulations, quality standards, and internal procedures, contributing to operational reliability and departmental organization. **Responsibilities** * Strictly comply with **Quality Management** guidelines and the company’s **Code of Conduct**. * Correctly use **PPE and Collective Protective Equipment (CPE)**, following applicable safety regulations and procedures for the position. * Keep the department and equipment organized according to the **5S Program**, safeguarding company assets. * Ensure proper maintenance of work instruments, requesting maintenance and calibration when necessary. * Perform tasks in accordance with company-provided training, instructions, and established procedures. * Meet production planning requirements, following cell reports and leaders’ instructions. * Immediately report any failures identified during task execution to the leader for analysis. * Record maintenance information in the **FAS system** and request **NCRs (Non-Conformance Reports)** whenever applicable. * Travel for work when required. **Technical Activities – Maintenance and Operations** * Assist in performing **preventive and corrective maintenance** on factory equipment. * Assist in operating, using, and performing preventive/corrective maintenance on the **test bench**. **Measuring Instruments** Support handling of various instruments, including: * Clamp wattmeter, dielectric strength analyzer, clamp ammeter, hipot tester, saturation curve indicator, power factor meter, megohmmeter, micro-ohmmeter, triple-time meter, caliper, thermo-hygrometer clock, phase sequence meter, oscilloscope, surge-tester, tachometer, earth resistance tester, infrared thermometer, turns ratio tester, vibration meter (measurements and software). **Electrical Tests** *On Motors:* * Insulation resistance, ohmic resistance, surge test, hipot test, loaded test, no-load test, loop test, voltage drop, overspeed, overshoot, corona effect, impedance, rotor cage armature test, rotating magnetic field, transformation reaction, polarity test, commutator eccentricity, and neutral line test. * *On Transformers:* * Insulation resistance, ohmic resistance, short-circuit test, insulation power factor, turns ratio, load losses, impedance, leak-tightness, and accessory tests. * *On Circuit Breakers:* * Insulation resistance, ohmic resistance, and oscillography. **Measurement Finishing** * Perform final finishing of the measurement stage, including sensors and cables. **Education Requirements** * **Preferred:** Technical course in Electrotechnology / Electronics / Mechatronics. * **Minimum:** Currently enrolled in a Technical course in Electrotechnology / Electronics / Mechatronics. **Experience** * **Preferred:** 6 months of experience. **Skills** * **Preferred:** Attention to detail, responsibility, and cooperation. Job type: Full-time, Permanent CLT Compensation: starting at R$1,00 per month Benefits: * Medical assistance * Dental assistance * Fuel allowance * Life insurance * Meal voucher Selection question(s): * Do you hold a technical qualification? Which one? * Register on our unified platform via the link https://hr.solides.com/talent\-bank Work location: On-site