Job Summary: This Electrical Technical Assistant supports maintenance activities, electrical testing, and equipment operation, ensuring reliability and organization. Key Highlights: 1. Supports preventive and corrective maintenance of equipment 2. Performs electrical tests on motors, transformers, and circuit breakers 3. Handles various measuring instruments **Job Description – Electrical Technical Assistant** We are seeking an **Electrical Technical Assistant** to support maintenance, electrical testing, and operation of equipment and instruments used in the factory. The professional must perform duties in accordance with safety regulations, quality standards, and internal procedures, contributing to operational reliability and departmental organization. **Responsibilities** * Ensure proper maintenance of work instruments, requesting maintenance and calibration as needed. * Perform tasks according to company-provided training, instructions, and established procedures. * Meet production planning requirements, following cell reports and supervisor guidance. * Immediately report any failures identified during task execution for supervisor analysis. * Record maintenance information in the **FAS** system and request **RNC** whenever applicable. * Travel for work when required. **Technical Activities** **Maintenance and Operations** * Assist in executing **preventive and corrective maintenance** of factory equipment. * Assist in operating, using, and performing preventive/corrective maintenance on the **test bench**. **Measuring Instruments** Support handling of various instruments, such as: * Clamp wattmeter, dielectric strength analyzer, clamp ammeter, hipot tester, saturation curve indicator, power factor meter, megohmmeter, micro-ohmmeter, triple-time meter, caliper, thermo-hygrometer clock, phase sequence meter, oscilloscope, surge-tester, tachometer, earth resistance tester, infrared thermometer, turns ratio meter, vibration meter (measurements and software). **Electrical Tests** On Motors: * Insulation resistance, ohmic resistance, surge-test, hipot test, loaded test, no-load test, loop-test, voltage drop, overspeed, overshot, corona effect, impedance, rotor cage induced current test, rotating magnetic field, transformation reaction, polarity test, commutator eccentricity, and neutral line test. On Transformers: * Insulation resistance, ohmic resistance, short-circuit test, insulation power factor, turns ratio, load losses, impedance, leak-tightness, and accessory tests. On Circuit Breakers: * Insulation resistance, ohmic resistance, and oscillography. **Measurement Finishing** * Perform final finishing of the measurement stage, including sensors and cables. **Requirements** **Education** * **Preferred:** Technical Course in Electrotechnology / Electronics / Mechatronics. * **Minimum:** Currently enrolled in a Technical Course in Electrotechnology / Electronics / Mechatronics. **Experience** * **Preferred:** 6 months of experience. **Skills** * **Preferred:** Attention to detail, responsibility, and cooperation.
João Silva
Indeed · HR
João Silva
Indeed · HR
