Job Summary: Electrical Technical Assistant to support maintenance activities, electrical testing, and operation of equipment, in compliance with safety and quality standards. Key Highlights: 1. Supports preventive and corrective maintenance of electrical equipment. 2. Performs electrical tests on motors, transformers, and circuit breakers. 3. Works with various electrical measuring instruments. **Job Description – Electrical Technical Assistant** We are seeking an **Electrical Technical Assistant** to support maintenance, electrical testing, and operation of equipment and instruments used in the factory. The professional must operate in accordance with safety regulations, quality standards, and internal procedures, contributing to operational reliability and departmental organization. **Responsibilities** * Strictly comply with **Quality Management** guidelines and the company’s **Code of Conduct**. * Properly use **PPE and collective protective equipment (CPE)**, adhering to applicable safety norms and procedures for the position. * Maintain the department and equipment organized according to the **5S Program**, preserving company assets. * Ensure proper care of work instruments, requesting maintenance and calibration as needed. * Perform tasks in accordance with company-provided training, instructions, and established procedures. * Meet production planning requirements, following cell reports and team leaders’ instructions. * Immediately report any issues identified during task execution to the team leader for analysis. * Record maintenance information in the **FAS system** and request **NCRs (Non-Conformance Reports)** whenever applicable. * Travel for work when necessary. **Technical Activities – Maintenance and Operations** * Assist in executing **preventive and corrective maintenance** of factory equipment. * Assist in operating, using, and performing preventive/corrective maintenance on the **test bench**. **Measuring Instruments** Support handling of various instruments, such as: * Clamp-on wattmeter, dielectric strength analyzer, clamp ammeter, hipot tester, saturation curve indicator, power factor meter, megohmmeter, micro-ohmmeter, triple-time meter, caliper, thermo-hygrometer clock, phase sequence meter, oscilloscope, surge tester, tachometer, earth resistance tester, infrared thermometer, turns ratio tester, vibration meter (measurements and software). **Electrical Tests** *On Motors:* * Insulation resistance, ohmic resistance, surge test, hipot test, loaded test, no-load test, loop test, voltage drop, overspeed, overshot, corona effect, impedance, rotor cage induced current test, rotating magnetic field, transformation reaction, polarity test, commutator eccentricity test, and neutral line test. * *On Transformers:* * Insulation resistance, ohmic resistance, short-circuit test, insulation power factor, turns ratio, load losses, impedance, leak-tightness, and accessory testing. * *On Circuit Breakers:* * Insulation resistance, ohmic resistance, and oscillography. **Measurement Finishing** * Perform final finishing of the measurement stage, including sensors and cables. **Education Requirements** * **Preferred:** Technical course in Electrotechnology / Electronics / Mechatronics. * **Minimum:** Currently enrolled in a Technical course in Electrotechnology / Electronics / Mechatronics. **Experience** * **Preferred:** 6 months of experience. **Skills** * **Preferred:** Attention to detail, responsibility, and cooperation. Job Type: Full-time, CLT (Consolidated Labor Laws) permanent position Compensation: Starting from R$1,00 per month Benefits: * Medical assistance * Dental assistance * Fuel allowance * Life insurance * Meal voucher Selection Question(s): * Do you hold a technical qualification? Which one? * Register on our unified platform via the link https://hr.solides.com/talent\-bank Work Location: On-site