Always check the electrical and electronic system status of the machine and/or equipment, as well as safety devices (record in the machine’s logbook), at the start of each shift; inspect for any other irregularities on the machine, such as unusual noises (pre-use equipment inspection); Operate material handling equipment (e.g., overhead cranes) with maximum care and strictly follow operational procedures and workplace safety rules, following specific training; Verify that produced products comply with quality standards, bear correct labels, and are stored properly; Assist in identifying, weighing, and directing non-conforming products; Align threads and adjust low-complexity machines; Cut the ties off coils loaded and stored in the designated drum, then transfer them to the scrap container; Load all storage units according to assigned priorities; Ensure cleanliness and maintenance of the machine and its accessories; Assess the machine’s condition, monitor it, and record findings in the table mounted beside the machine (downtime control); Carry out routine operational tasks by adjusting and operating low-complexity machines and equipment; Control product quality by performing measurements and monitoring, with proper documentation; Operate machines and/or equipment with maximum care for the equipment itself, adhering to operational procedures (ITs) and workplace safety rules; Inspect cutting blades’ condition and record findings in the machine’s logbook; Monitor machine constraints and production requirements according to the defined sequence; Check for incomplete work orders (WOs) and production needs; Release parts for delivery based on measurement results; Assist in the training process of Factory Assistants; Organize the workplace; Other duties relevant to the position. **Minimum Education Level:** High School (Secondary Education)