**Job Description – Electrical Technical Assistant** We are seeking an **Electrical Technical Assistant** to support maintenance activities, electrical testing, and operation of equipment and instruments used in the factory. The professional must perform duties in accordance with safety regulations, quality standards, and internal procedures, contributing to operational reliability and departmental organization. **Responsibilities** * Strictly comply with the directives of **Quality Management** and the company’s **Code of Conduct**. * Correctly use **PPE and collective protective equipment (CPE)**, following applicable safety norms and procedures for the position. * Maintain the department and equipment organized in accordance with the **5S Program**, preserving company assets. * Ensure proper maintenance of work instruments, requesting maintenance and calibration as needed. * Perform tasks in accordance with company-provided training, instructions, and established procedures. * Fulfill production planning by following cell reports and team leaders’ instructions. * Immediately report any failures identified during task execution to the supervisor for analysis. * Record maintenance information in the **FAS system** and request **Non-Conformance Reports (NCRs)** whenever applicable. * Undertake business travel when required. **Technical Activities** **Maintenance and Operations** * Assist in performing **preventive and corrective maintenance** on factory equipment. * Assist in operating, using, and performing preventive/corrective maintenance on the **test bench**. **Measuring Instruments** Support handling of various instruments, including: * Clamp-on wattmeter, dielectric strength analyzer, clamp ammeter, hipot tester, saturation curve indicator, power factor meter, megohmmeter, micro-ohmmeter, triple-time meter, caliper, thermo-hygrometer clock, phase sequence meter, oscilloscope, surge tester, tachometer, earth resistance tester, infrared thermometer, turns ratio tester, vibration meter (measurements and software). **Electrical Tests** On Motors: * Insulation resistance, ohmic resistance, surge test, hipot test, loaded test, no-load test, loop test, voltage drop, overspeed, overshoot, corona effect, impedance, rotor cage induced current test, rotating magnetic field test, transformation reaction test, polarity test, commutator eccentricity test, and neutral line test. On Transformers: * Insulation resistance, ohmic resistance, short-circuit test, insulation power factor, turns ratio, load losses, impedance, leak-tightness, and accessory tests. On Circuit Breakers: * Insulation resistance, ohmic resistance, and oscillography. **Measurement Finishing** * Perform final finishing of the measurement stage, including sensors and cables. **Requirements** **Education** * **Preferred:** Technical course in Electrotechnology / Electronics / Mechatronics. * **Minimum:** Currently enrolled in a Technical course in Electrotechnology / Electronics / Mechatronics. **Experience** * **Preferred:** 6 months of experience. **Skills** * **Preferred:** Attention to detail, responsibility, and cooperation.